Welcome to part 5 of the Amateur Surgeon 3 All Patients Walkthrough! Click here to go back to part four of the guide.
Use the pizza cutter to cut into the eye along the orange lines. Vacuum up the fire, then staple the big cuts and cauterize all cuts. Apply ointment to the cuts and burns. On the next screen, do the same thing (vacuum, staple, cauterize, ointment) On the next screen cut the parts off with the chainsaw along the yellow lines, then place them into the tray with the tongs. Fit the new part on with the tongs, weld with the lighter, and apply ointment. Vacuum up the fire as needed.
Staple the eye cut, then cauterize and apply ointment. Cut the eye out with the chainsaw (yellow lines), then put it into the tray, fit the new eye with the tongs, then weld along the black lines and apply ointment along the green lines.
Vacuum the fire, suck poison out with the red syringe, staple the big cuts shut, then cauterize all cuts and apply ointment to both cuts and burns. Cut into the heart, then chainsaw the mucus and suck out the poison with the red syringe and vacuum the bubbles. Vacuum the fire and put ointment on the burn marks. Staple, cauterize and apply ointment to the big cut.
Chainsaw the arm off along the yellow lines, then pull it and put it into the tray with the tongs, then fit the new arm using the tongs. Apply clamps to arteries (by double tapping) about half a centimeter up from the bleed point, then twist clockwise to close the clamps. Use tongs to move the arteries if you can’t reach them with the clamps. Use the tongs to put them together once they are clamped. Weld them with the lighter and apply ointment. Fit the “bones” back together and then weld and apply ointment along the black lines and green lines. Repeat for the rest of the limbs.
At the circuit board, vacuum the fire, staple the big cuts, cauterize all of the cuts, then apply ointment to the cuts and the burn marks. Chainsaw the old part out along the yellow lines, put it in the tray with the tongs, then fit the new part, weld it in with the lighter and apply ointment. Repeat for the rest of the parts. At the next screen reattach the bone by welding it on the black lines and putting ointment on the green lines.
Cauterize and apply ointment to all of the little cuts. On the next screen, zap the scorpion with the car battery, then put the clamp on them, twist it down, and then use the chainsaw to kill them, then use the tongs to put them in the tray. Use the scanner to find any more scorpions and do the same thing to them. Pull the tools out of the big cuts, staple big cuts, cauterize and heal all cuts. Staple, cauterize and heal the rest of the cuts.